It s the sequential circuits pro one it doesn t give sound if you put in a balanced jack.
Balanced or unbalanced cables for synth.
The structure of a balanced audio cable is similar to an unbalanced cable with one addition.
The main difference comparing balanced vs unbalanced cables is a balanced cable has 1 additional conductor.
The diagram above shows how the cable works.
All others are unbalanced outs and ins.
Use unbalanced cables when you have unbalanced instrument outputs.
I have a roland jv1010 sound module and an m audio usb audio quattro that i need to hook up.
The balanced cable will have 1 hot 1 cold and a ground shielding.
A typical unbalanced cable like a 1 4 instrument cable has 2 conductors.
Just use good quality ts to ts type cables.
A balanced audio cable has a ground wire but it also carries two copies of the same incoming audio signal sometimes referred to as a hot positive and cold negative signal.
This is especially true if it needs to be used in an environment where there s a lot of lights and other stuff that could cause interference.
The roland instruction manual does not mention whether i should use balanced or unbalanced cables.
Some higher end synths may have xlr output jacks which are balanced and balanced cables are what would be used.
Maybe someone could help me a bit and knows for sure which of these synths are balanced unbalanced.
You can with some caveats.
Oscar sh 101 ems synthi a moog the source tr 808 tr 909 ms.
I m trying to understand when to use balanced and unbalanced cables once and for all.
Most audio interfaces have inputs which are properly wired to support both balanced and unbalanced 1 4 connections although some are auto switching while others have a physical line inst switch line balanced inst unbalanced.
The advantage of using balanced cables to connect between balanced outputs and balanced inputs is that balanced connections have better noise rejection thanks to a second inverted signal that has equal resistance to ground as the initial signal this inverted or reverse polarity signal is used to cancel noise and to make the signal more robust.
The 1st conduction is the audio signal itself and the 2nd is a ground and often a shielding.
If the synth has 1 4 6 3mm jacks for outputs they are very likely unbalanced and using balanced cables will not be of a benefit.
